Setting up software

Owned by Victor Stoltze
Last updated: Jun 29, 2022 by Jonathan Rógvi Højsted
1 min read

Follow these steps to install the scanner software.

  Instructions

  1. Connect scanner and cradle to the pc

  2. Download and install this driver below called CP210x_VCP_Win7.exe

  3. Download and install this file below called Statusscanner.msi

  4. Run the Status application placed on the desktop

  5. Go to C: drive and the if there is a folder called Munkdata, if not then right and create it.

  6. Please check the COM port called Silicon Labs CP210x USB to UART Bridge in Device manager and then fold out Ports (COM & LPT)

  7. Make sure the settings are like this (Expect COM port, that one should fit Silicon Labs CP210x USB to UART Bridge)