In this section you will be guided through the setup of the scanner.
\uD83D\uDCD8 Instuctuctions
If your scanners looks like the picture below, we need to install another firmware, otherwise you’re good to go.
Start by download and install this program
Download this file
Go to C:\CipherLab\Forge\Batch\8 Series and open ForgeAG.exe
Go to File → Open → And choose UK-Kvik-NY.AGX (The file you just downloaded)
Press this icon
Download via: "Cradle-IR"
Check the com port, in Device manager under Ports (COM & LPT)
Set the baud rate to 57600bps
Click OK
The scanner should now look like this.
\uD83D\uDCD8 Instructions
Connect scanner and cradle to the pc
Download and install this driver
Go to Device manager and and fold out Ports (COM & LPT)
Right click on Silicon Labs CP210x USB to UART Bridge
Go to Port settings and set Bits per second to 57600
Pick up the scanner and change these 2 things
Utilities -> Settings -> Baud Rate -> 57600 bps
Utilities -> Load application -> Dock Scanner